DTC Confirmation Procedure

PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

NOTE: Procedure for malfunction B is not described here. It takes extremely long time to complete procedure for malfunction B. By performing procedure for malfunction A, the incident that causes malfunction B can be detected.

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

Start engine.
Press MAIN switch and make sure that CRUISE indicator is displayed in combination meter.

Drive the vehicle for at least 5 consecutive seconds under the following conditions.

CAUTION: Always drive vehicle at a safe speed.

NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

DTC CONFIRMATION PROCEDURE CONDITION (MALFUNCTION A)

Vehicle speed	More than 30 km/h (19 mph)
Shift lever	Suitable position

Check 1st trip DTC.

Is 1st trip DTC detected?

YES: GO TO "DIAGNOSIS PROCEDURE ".

NO: GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

Drive the vehicle for at least 5 consecutive seconds under the following conditions.

CAUTION: Always drive vehicle at a safe speed.

NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

DTC CONFIRMATION PROCEDURE CONDITION (MALFUNCTION B)

Vehicle speed	More than 30 km/h (19 mph)
Selector lever	Suitable position
Driving location	Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned vehicle speed.

Check 1st trip DTC.

Is 1st trip DTC detected?

YES: GO TO "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END