Oil Pump: Assembly

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Install O-ring to oil pump cover.
CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
  
  Fig 1: Identifying O-Ring To Oil Pump Cover
Install O-ring to oil pump housing.
CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
  
  Fig 2: Identifying O-Ring
Install oil pump housing oil seal to the oil pump housing until it is flush using Tool.
Tool number : ST33400001 (J-26082)
CAUTION:
- Do not reuse oil seal.
- Apply ATF to oil seal.
  
  Fig 3: Identifying Oil Pump Housing Oil Seal To Oil Pump Housing
After temporarily tightening the bolts for the oil pump housing to the oil pump cover, tighten them to the specified torque in the sequence shown.
Oil pump housing bolts : 9.0 N.m (0.92 kg-m, 80 in-lb.)

Fig 4: Identifying Tightening Sequence Of Bolts