IPDM E/R Operation Check

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IPDM E/R INPUT VOLTAGE

Check voltage between IPDM E/R connector E122 terminal 45 and ground.

VOLTAGE CHART

Connector	Terminal		Voltage (V) (Approx.)
Connector	(+)	(-)	Voltage (V) (Approx.)
E122	45	Ground	Battery voltage

Fig 1: Checking Voltage Between IPDM E/R Connector E122 Terminal 45 And Ground

OK or NG

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: GO TO 2.

CHECK IPDM E/R INPUT VOLTAGE CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R and horn relay.
3. Check continuity between IPDM E/R connector E122 terminal 45 and horn relay connector H-1 terminal 1.
  45 - 1 : Continuity should exist.
4. Check continuity between IPDM E/R connector E122 terminal 45 and ground.
  45 - Ground : Continuity should not exist.
OK or NG

OK: Further inspection is necessary. Refer to "SYMPTOM CHART ".

NG: Repair or replace harness.

Fig 2: Checking Continuity Between IPDM E/R Connector E122 Terminal 45 And Connector H-1 Terminal 1