Diagnosis Procedure
- CHECK CONTINUITY AUX IMAGE SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect auxiliary input jacks connector and front display unit connector.
- Check continuity between auxiliary input jacks harness connector and front display unit harness connector.CONTINUITY REFERENCE CHART
Auxiliary input jacks Front display unit Continuity Connector Terminals Connector Terminals M258 7 M75 15 Existed 8 5 - Check continuity between front display unit harness connector and ground.CONTINUITY REFERENCE CHART
Front display unit Ground Continuity Connector Terminal M75 15 Not existed Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK AUX IMAGE SIGNAL
- Connect auxiliary input jacks connector and front display unit connector.
- Turn ignition switch ON.
- Check signal between AV control unit harness connector using an oscilloscope.SIGNAL WAVEFORM REFERENCE CHART
(+) (-) Condition Reference value Front display unit Front display unit Connector Terminal Connector Terminal M75 15 M75 5 When AUX image is displayed. Is the inspection result normal?
YES: Replace front display unit.
NO: Check that there is no malfunction in the external device.