Diagnosis Procedure
- CHECK CONTINUITY RGB SYNCHRONIZING SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect front display unit connector and AV control unit connector.
- Check continuity between front display unit harness connector and AV control unit harness connector.CONTINUITY REFERENCE CHART
Front display unit AV control unit Continuity Connector Terminal Connector Terminal M75 19 M86 65 Existed - Check continuity between front display unit harness connector and ground.CONTINUITY REFERENCE CHART
Front display unit Ground Continuity Connector Terminal M75 19 Not existed Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK RGB SYNCHRONIZING SIGNAL
- Connect front display unit connector and AV control unit connector.
- Turn ignition switch ON.
- Check signal between front display unit harness connector and ground using an oscilloscope.SIGNAL WAVEFORM REFERENCE CHART
(+) (-) Condition Reference value Front display unit Connector Terminal M75 19 Ground - Is the inspection result normal?
YES: Replace front display unit.
NO: Replace AV control unit.