Element Check

WARNING: This page is about a different variant/trim than selected.

Attach probe circuit tester (ohm setting) to antenna terminal on each side.

Fig 1: Attaching Probe Circuit Tester To Antenna Terminal
Courtesy of NISSAN MOTOR CO., U.S.A.
- When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
Fig 2: Wrapping Tin Foil Around Top Of Probe
Courtesy of NISSAN MOTOR CO., U.S.A.
If an element is broken, no continuity will exist.

Fig 3: Checking Continuity Of Broken Element
Courtesy of NISSAN MOTOR CO., U.S.A.
To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

Fig 4: Moving Probe Along Filament To Locate Burned Out Points

Courtesy of NISSAN MOTOR CO., U.S.A.