LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Hybrid Control System - Introduction) >> Function Diagnosis >> On Board Diagnostic (OBD) System >> CONSULT-III Function >> Active Test Mode >> Test Item
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Item

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Using the CONSULT-III to perform active tests allows relays, actuators and other items to be operated without removing any parts. This non intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing active tests early in troubleshooting is one way to save diagnostic time. Data monitor information can be displayed while performing active tests.
ACTIVE TEST MODE REFERENCE CHART

TEST ITEM TEST PART CONTROL RANGE TEST DETAILS TEST CONDITION
INSPECTION MODE 1 (Inspection mode-2WD inspection)
  • To check engine running operation
  • To release traction control while using a speedometer tester
 ON or OFF
  • Runs the engine continuously with the shift lever in the P position
  • Releases traction control that is initiated when the rotational difference between the front and rear wheels is excessive with the shift lever in any position other than P
 Ignition switch ON, HV system normal, not in maintenance mode, and other active tests not being done
INSPECTION MODE 2 (Inspection mode-2WD chassis-dynamo) To release traction control while using a speedometer tester ON or OFF Releases traction control that is initiated when the rotational difference between the front and rear wheels is excessive with the shift lever in any position other than P Ignition switch ON, HV system normal, not in maintenance mode, and other active tests not being done
COMPRESSION TEST (Compression Test) To crank the engine continuously in order to measure the compression ON or OFF Allows the engine to continue cranking by activating the MG1 continuously
  • Ignition switch ON, HV system normal, not in maintenance mode, and other active tests not being done
  • This test is available when keeping to push ignition switch with brake pedal depressed.
INV WATER PUMP (Activate the Water Pump) To activate the inverter water pump continuously ON or OFF Activates the inverter water pump continuously Ignition switch ON, inverter system normal, not in maintenance mode, and other active tests not being done
COOLING FAN SPD (Driving the battery cooling fan) To check operation of the cooling fan and if there is sufficient air flow 0 to 6 Stops the cooling fan or changes air volume mode (1 to 6) -
DC/DC CONVERTER To check operation of the DC/DC converter ON or OFF Change the voltage that is supplied to auxiliary battery
  • Ignition switch ON, not in maintenance mode
  • Turn ignition switch to READY position
  • Keep the shift lever "P" position
scientia non olet · About LEMON Manuals