LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Cube Base >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Transmitter ID Registration Without Transmitter Activation Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmitter ID Registration Without Transmitter Activation Tool

NOTE: This procedure must be done after replacing or rotating wheels, replacing transmitter or BCM.
  1. With the ignition switch in OFF position, connect scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Display "WORK SUPPORT" screen, and select "ID REGIST".
  3. Set the tire pressure of each wheel to the specification shown in the Sensor ID Registration Tire Pressure Specifications  table. Then drive the vehicle at 20 mph (32 km/h) or above for more than 3 minutes.
    Sensor ID Registration Tire Pressure Specifications

    Tire Position Tire Pressure - psi (kPa)
    Front Left 35 (240)
    Front Right 32 (220)
    Rear Right 29 (200)
    Rear Left 26 (180)
  4. After completing all ID registrations, press "END" to complete the procedure.
  5. Inflate all tires to specification.
scientia non olet · About LEMON Manuals