LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Cube Base >> Repair and Diagnosis >> Quick Lookups >> Common Specs & Procedures >> Specifications Index
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Specifications Index

CUBE SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
  Service SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque See applicable components in HEATER & AIR CONDITIONING SYSTEM article.
Axle Nut/Hub Nut
  Front Hub Nuts 125 N.m (92 Ft. lbs)
Battery SERVICE DATA AND SPECIFICATIONS (SDS)
Brakes
  Bleeding Sequence BLEEDING BRAKE SYSTEM
  Disc Brakes
    Front and Rear SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque
    Front Refer to applicable components under:
FRONT DISC BRAKE
    Rear Refer to applicable components under:
REAR DRUM BRAKE
Charging
  Generator ALTERNATOR
  Torque Refer to applicable components under:
REMOVAL AND INSTALLATION
Drive Belts
  Adjustment DRIVE BELT
  Belt Routing DRIVE BELT : EXPLODED VIEW
Engine Cooling
  General Service Specifications SERVICE DATA AND SPECIFICATIONS (SDS)
  Radiator Cap Pressure 78 - 98 kPa (0.8 - 1.0 kgf/cm2 , 11 - 14 psi)
  Thermostat R & I THERMOSTAT
  Water Pump R & I WATER PUMP
Engine Mechanical
  Compression COMPRESSION PRESSURE
  Oil Pressure (Engine oil temperature at 80°C (176°F))
    @ Idle 60 kPa (.061 kgf/cm2 , 9 psi)
    @ 2000 RPM 200 kPa (2.0 kgf/cm2 , 29 psi)
  Overhaul SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque See applicable component in SERVICE DATA AND SPECIFICATIONS (SDS) article.
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint" button.
Flywheel/Flex Plate (Drive Plate) Torque 108 N.m (80 Ft. lbs)
Fuel System
  Fuel Pressure Release Procedure FUEL PRESSURE RELEASE
  Pressure Specification At Idling: Approximately 350 kPa (3.57 kg/cm2 , 51 psi)
  Fuel Pressure Test Procedure FUEL PRESSURE CHECK
  Fuel Filter Location In Tank Type
  Fuel Filter R & I FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
Ignition
  Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
  Ignition Wires (Resistance) Coil On Plug
  Ignition Wires (Routing) NA
  Spark Plugs SPARK PLUG
Tightening torque: 19.6 N.m (14 ft. Lbs)
Starting
  Starter STARTER MOTOR
  Torque STARTER MOTOR
Wheel Alignment
  Adjustment Specifications
    Front WHEEL ALIGNMENT
    Rear WHEEL ALIGNMENT
  Torque
    Front See applicable components in FRONT SUSPENSION article.
    Rear See applicable components in REAR SUSPENSION article.
Wheel & Tire
  Wheel Lug Nut Torque 108 N.m (11 kg. m, 80 Ft. lbs)
How To Use Nissan/Infiniti Service Information
  Includes:
Standard Bolt Torque
Symbol Identification
General Connector Info
GENERAL INFORMATION