Component Inspection

1. Turn ignition switch OFF.
2. Disconnect electric throttle control actuator harness connector.
3. Check resistance between electric throttle control actuator terminals as per the following.
   RESISTANCE REFERENCE
   
   

   Terminals	Resistance
   5 and 6	Approx. 1 - 15 Ω [at 25°C (77°F)]

   Fig 1: Checking Resistance Between Electric Throttle Control Actuator Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

: INSPECTION END