Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "SPECIAL REPAIR REQUIREMENT ".
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.
   VOLTAGE SPECIFICATION
   
   

   ECM			Condition		Voltage
   Connector	+	-
   	Terminal	Terminal
   F13	37 (TP sensor 1 signal)	36 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36 V
   				Fully depressed	Less than 4.75 V
   	38 (TP sensor 2 signal)			Fully released	Less than 4.75 V
   				Fully depressed	More than 0.36 V

   Fig 1: Checking Voltage Between ECM Harness Connector Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

: INSPECTION END