Component Inspection

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check the voltage between ECM harness connector terminals under the following conditions.
   VOLTAGE SPECIFICATION
   
   

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   E10	81 (APP sensor 1 signal)	84 (Sensor ground)	Accelerator pedal	Fully released	0.65 - 0.87
   				Fully depressed	More than 4.3
   	82 (APP sensor 2 signal)	100 (Sensor ground)		Fully released	0.28 - 0.48
   				Fully depressed	More than 2.0

   Fig 1: Checking Voltage Between ECM Harness Connector Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

: INSPECTION END