Inspection Procedure

Turn ignition switch OFF.
Connect "GST" to data link connector (2), which is located under LH dash panel.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Enter the program according to instruction on the screen or in the operation manual.
(*: Regarding GST screens in this information, sample screens are shown.)

Fig 2: GST Sample Screens Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic mode according to each service procedure.
For further information, see the GST Operation Manual of the tool maker.

Fig 3: Generic Scan Tool Screen Display - Readiness Tests
Courtesy of NISSAN MOTOR CO., U.S.A.