Keyfob Battery and Function Check
- CHECK KEYFOB BATTERY
Remove battery and measure voltage across battery positive and negative terminals, (+) and (-).
Voltage : 2.5V - 3.0V
NOTE: Keyfob does not function if battery is not set correctly.OK or NG
OK: GO TO 2.
NG: Replace keyfob battery. Refer to "KEYFOB BATTERY REPLACEMENT ".
- CHECK KEYFOB FUNCTION
With CONSULT-III
Check keyfob function in "DATA MONITOR" mode with CONSULT-III.
When pushing each button of keyfob, the corresponding monitor item should be turned as follows .
DATA MONITORCondition Monitor item Pushing LOCK KEYLESS LOCK : ON Pushing UNLOCK KEYLESS UNLOCK : ON Keep pushing UNLOCK RKE KEEP UNLK turns to ON 3 seconds after UNLOCK button is pushed. Pushing PANIC KEYLESS PANIC : ON Pushing LOCK and UNLOCK at the same time RKE LCK-UNLCK : ON Pushing SLID DOOR RH OPEN KEYLESS PSD (1) : ON KEYLESS PSD R (2) : ON Pushing SLID DOOR LH OPEN KEYLESS PSD L (2) : ON (1) With auto sliding door RH (2) With auto sliding door RH and LH Without CONSULT-III
Check keyfob function using Remote Keyless Entry Tester J-43241.
OK or NG
OK: WITH CONSULT-III: Keyfob, remote keyless entry receiver and wiring harness between BCM and remote keyless entry receiver are OK. Replace BCM. Refer to REMOVAL AND INSTALLATION OF BCM .
OK: WITHOUT CONSULT-III: Keyfob is OK. Further inspection is necessary. Refer to "TROUBLE DIAGNOSIS ".
NG: WITH CONSULT-III: Further inspection is necessary. Refer to "TROUBLE DIAGNOSIS ".
NG: WITHOUT CONSULT-III: Replace keyfob. Refer to "ID CODE ENTRY PROCEDURE ".