Sleep mode activation
- IPDM E/R judges that the sleep-ready conditions are fulfilled when the ignition switch is OFF and none of the conditions below are present. Then it transmits a sleep-ready signal (ready) to BCM via CAN communication.
- Front wiper fail-safe operation
- Ignition relay ON or OFF stuck detection
- Outputting signals to actuators
- Switches or relays operating
- Auto active test is starting
- Communicating with CONSULT-III
- Hood switch status is changed (For Mexico)
- Output requests are being received from control units via CAN communication.
- IPDM E/R stops CAN communication and enters the low power consumption mode when it receives a sleep wake up signal (sleep) from BCM and the sleep-ready conditions are fulfilled.