Component Inspection

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check the voltage between ECM harness connector terminals.
   CONNECTOR TERMINAL VOLTAGE CHART
   
   

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   E16	81 (APP sensor 1 signal)	E16	84 (Sensor ground)	Accelerator pedal	Fully released	0.6 - 0.9 V
   					Fully depressed	3.9 - 4.7 V
   	82 (APP sensor 2 signal)		100 (Sensor ground)		Fully released	0.3 - 0.6 V
   					Fully depressed	1.95 - 2.4 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

INSPECTION END