LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R Spec V, RS6F52A >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - Component Testing (MR20DE Except CALIFORNIA)) >> ASCD Brake Switch >> Component Inspection >> ASCD Brake Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ASCD Brake Switch

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Disconnect ASCD brake switch harness connector.
  3. Check continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
    CONTINUITY REFERENCE CHART

    Condition Continuity
    Brake pedal: Fully released. Should exist.
    Brake pedal: Slightly depressed. Should not exist.

    If NG, adjust ASCD brake switch installation, refer to BRAKE PEDAL , and perform step  3 again.

    Fig 1: Checking Continuity Between ASCD Brake Switch Terminals 1 And 2
    G05922444Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals