LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 8 (Engine Control System - Introduction (MR20DE-CALIFORNIA)) >> Service Information >> On Board Diagnostic (OBD) System >> Malfunction Indicator Lamp (MIL) >> How To Switch Diagnostic Test Mode >> How to Erase Diagnostic Test Mode II (Self-diagnostic Results)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How to Erase Diagnostic Test Mode II (Self-diagnostic Results)

WARNING: This page is about a different variant/trim than selected.
  1. Set ECM in Diagnostic Test Mode II (Self-diagnostic results).

    Refer to "HOW TO SET DIAGNOSTIC TEST MODE II (SELF-DIAGNOSTIC RESULTS) ".

  2. Fully depress the accelerator pedal and keep it for more than 10 seconds.

    The emission-related diagnostic information has been erased from the backup memory in the ECM.

  3. Fully release the accelerator pedal, and confirm the DTC 0000 is displayed.
scientia non olet · About LEMON Manuals