DTC Confirmation Procedure

TESTING CONDITION: 

• Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface  .
• Always perform test at a temperature of 0 to 10°C (32 to 140°F)  .
• Open engine hood before conducting following procedure  .

WITH CONSULT-III

1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
4. Check the following conditions are met.

   COOLAN TEMP/S: 0 - 100°C (32 - 212°F) 

   INT/A TEMP SE: 0 - 60°C (32 - 140°F) 

5. Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.

   Follow the instruction displayed.

   NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-III screen, go to "BASIC INSPECTION ".
6. Check that "OK" is displayed.

   If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

WITH GST

1. Start engine.
2. Drive vehicle according to Driving Pattern, "EMISSION-RELATED DIAGNOSTIC INFORMATION "
3. Stop vehicle.
4. Turn ignition switch OFF and wait at least 10 seconds and then turn ignition switch ON.
5. Select Service $07 with GST.
   • If P0442 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".
   • If P0441 is displayed on the screen, go to "DIAGNOSIS PROCEDURE " for DTC P0441.