Throttle Control Motor

WARNING: This page is about a different variant/trim than selected.

Disconnect electric throttle control actuator harness connector.
Check resistance between terminals 5 and 6.
Resistance: Approximately 1 - 15 Ω [at 25 °C (77°F)]
If NG, replace electric throttle control actuator and go to next step.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Perform "IDLE AIR VOLUME LEARNING ".

Fig 1: Checking Resistance Between Terminals 5 And 6
Courtesy of NISSAN MOTOR CO., U.S.A.