LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Versa Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0500 To P2A00 >> DTC P1217 Engine Over Temperature >> Overall Function Check >> With GST >> Models without A/C
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Models without A/C

  1. Check the coolant level in the reservoir tank and radiator.

    Allow engine to cool before checking coolant level  .

    If the coolant level in the reservoir tank and/or radiator is below the proper range, skip the following steps and go to "DIAGNOSIS PROCEDURE ".

  2. Confirm whether customer filled the coolant or not. If customer filled the coolant, skip the following steps and go to "DIAGNOSIS PROCEDURE ".
  3. Perform IPDM E/R auto active test and check cooling fan motor operation, refer to AUTO ACTIVE TEST .
  4. Make sure that cooling fan operate at low speed.

    If NG, go to "DIAGNOSIS PROCEDURE ".

    Fig 1: Identifying Coolant Level
    G04875329Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Turn ignition switch OFF.
  6. Disconnect engine coolant temperature sensor harness connector.
  7. Connect 150Ω resistor to engine coolant temperature sensor harness connector.
  8. Start engine and make that cooling fan operates. Be careful not to overheat engine.
  9. If NG, go to "DIAGNOSIS PROCEDURE ".
    Fig 2: Identifying Cooling Fan And Engine Coolant Temperature Sensor Harness Connector
    G05932875Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals