Specifications With Consult-III
CAUTION:
The output signal indicates the EPS control unit calculation date. The normal values will be displayed even in the event that the output circuit (harness) is open.
INPUT/OUTPUT SIGNAL REFERENCE VALUES CHART
| Monitor item (Unit) |
Content |
Condition |
Display value |
| MOTOR VOL (V) |
Power supply voltage for EPS control unit |
Ignition switch: ON |
Battery voltage |
| TORQUE SENSOR (Nm) |
Steering wheel turning force |
Engine running |
Steering wheel: Not steering (There is no steering force) |
0.00 Nm |
| Steering wheel: Steering |
0 - 8.19 Nm (The value is changed according to steering left or right) |
| MOTOR SIG (A) |
Command current to EPS motor |
Engine running |
Steering wheel: Not steering (There is no steering force) |
0.00 A |
| Steering wheel: Steering |
0 - 65.00 A (The value is changed according to steering left or right) |
| MOTOR CURRENT (A) |
Consumption current of EPS motor |
Engine running |
Steering wheel: Not steering (There is no steering force) |
0.00 A |
| Steering wheel: Steering |
0 - 65.00 A(The value is changed according to steering left or right) |
| VEHICLE SPEED (km/h) or (mph) |
Vehicle speed |
Vehicle stopped |
0 km/h (0 mph) |
| While driving |
Approximately equal to the indication on speedometer (Inside of ±10%) |
| WARNING LAMP (ON/OFF) |
EPS warning lamp condition |
EPS warning lamp: ON |
ON |
| EPS warning lamp: OFF |
OFF |
| DERATING STAT (ON/OFF) |
Protect overload status |
Engine running |
Steering wheel: Normal steering |
OFF |
| Steering wheel: Steering over the stop |
ON |
| ENGINE STATUS (RUN/STOP) |
Engine status |
Engine stopped (Engine speed: Less than 400 RPM) |
STOP |
| Engine running (Engine speed: 400 RPM or more) |
RUN |