Component Inspection
- CHECK FUEL TANK TEMPERATURE SENSOR
- Turn ignition switch OFF.
- Disconnect "fuel level sensor unit and fuel pump" harness connector.
- Remove fuel level sensor unit.
- Check resistance between "fuel level sensor unit and fuel pump" terminals by heating with hot water as shown in the figure.
RESISTANCE SPECIFICATIONTerminals Condition Resistance 4 and 5 Temperature [°C (°F)] 20 (68) 2.3 - 2.7 kΩ 50 (122) 0.79 - 0.90 kΩ Is the inspection result normal?
YES: INSPECTION END
NO: Replace "fuel level sensor unit and fuel pump".