DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10 V at idle. 

GO TO 2.

1. Turn ignition switch ON.
2. Turn ignition switch OFF, wait at least 10 seconds.
3. Turn ignition switch ON.
4. Repeat steps 2 and 3 for 32 times.
5. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END