Component Function Check

TESTING CONDITION: 

• Before performing the following procedure, confirm that battery voltage is more than 12.8 V at idle. 
• Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF. 

GO TO 2.

With CONSULT-III 

1. Start engine and let it idle.
2. Select "BAT CUR SEN" in "DATA MONITOR" mode with CONSULT-III.
3. Check "BAT CUR SEN" indication for 10 seconds.

   "BAT CUR SEN" should be above 2, 300 mV at least once. 

   Without CONSULT-III 

   1. Start engine and let it idle.
   2. Check the voltage between ECM harness connector and ground.
   TERMINAL VOLTAGE REFERENCE CHART
   
   

   ECM			Voltage
   Connector	+	-
   	Terminal	Terminal
   F8	58 (Battery current sensor signal)	68	Above 2.3 V at least once

Is the inspection result normal? 

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE "