LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2010 >> Sentra SE-R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transmission (CVT) >> Service Information >> Precautions >> Service After Replacing TCM, Transaxle Assembly, or Control Valve >> Pattern B
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pattern B

  1. Turn ignition switch ON after replacing each part.
  2. Connect the vehicle with CONSULT-III.
  3. Start engine.
    CAUTION: Never start driving.
  4. Select "Data monitor" in "TRANSMISSION".
  5. Warm up transaxle assembly until "ATFTEMP COUNT" indicates 47 [approximately 20°C (68°F)] or more, and then turn ignition switch OFF.
  6. Turn ignition switch ON.
    CAUTION: Never start engine.
  7. Select "Self Diagnostic Results" in "TRANSMISSION".
  8. Shift the selector lever to "R" position.
  9. Depress slightly the accelerator pedal (Pedal angle: 2/8) while depressing the brake pedal.
  10. Attempt to select "Erase" with step  9.
  11. Release brake pedal and accelerator pedal.
  12. Turn ignition switch OFF while keeping the selector lever in "R" position.
  13. Wait approximately 10 seconds.
  14. Turn ignition switch ON while keeping the selector lever in "R" position.
  15. Select "Special function" in "TRANSMISSION".
  16. Check that the value on "CALIB DATA" in CONSULT-III is the same as the data listed in the table below.
    • Restart the procedure from step  3 if the values are not the same.

      CALIB DATA

      ITEM DISPLAY VALUE CHART

      Item name Display value
      UNIT CLB ID 1 00
      UNIT CLB ID 2 00
      UNIT CLB ID 3 00
      UNIT CLB ID 4 00
      UNIT CLB ID 5 00
      UNIT CLB ID 6 00
  17. Shift the selector lever to "P" position.
  18. Check that the shift position indicator in combination meter turns ON. (It indicates approximately 1 or 2 seconds after shifting the selector lever to "P" position.)
    • Check the following items if shift position indicator does not turn ON. Repair or replace accordingly as necessary.
      • The harness between TCM and ROM ASSY in transaxle assembly is open or shorted.
      • Terminals disconnected, loose, or bent from connector housing.
      • Power supply and ground of TCM. Refer to "DESCRIPTION ".
scientia non olet · About LEMON Manuals