Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Installation is in the reverse order of removal.
NOTE:
- When installing the inverter, lower RH bracket, lower LH bracket, rear LH bracket, rear RH bracket and upper LH bracket should be attached to the inverter in advance.
- When lower RH bracket, lower LH bracket, rear LH bracket, rear RH bracket and upper LH bracket are attached to the inverter, they should be touched to anti-rotation at the boss of the inverter.
- When tightening bolts, perform the following procedure:
- Temporarily tighten the bolts A, B, E, F.
- Connect MG1 harness connector and MG2 harness connector.
- Fully tighten the bolts H, K.
- Fully tighten the bolts G, I, J and L.
- Fully tighten the bolt F.
- Fully tighten the bolts A, B, C, D, E.
- Refill the engine coolant and check for leaks. Refer to "CHANGING ENGINE COOLANT ".