Component Inspection

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check the voltage between ECM harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   E16	110 (APP sensor 1 signal)	Ground	Accelerator pedal	Fully released	0.6 - 0.9 V
   				Fully depressed	3.9 - 4.7 V
   	103 (APP sensor 2 signal)			Fully released	0.3 - 0.6 V
   				Fully depressed	1.95 - 2.4 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to 2.

Replace accelerator pedal assembly. Refer to "REMOVAL AND INSTALLATION ".

INSPECTION END