Removal And Installation

ACCELERATOR CONTROL SYSTEM

Removal and Installation


REMOVAL

1.Disconnect accelerator pedal position sensor harness connector.
2.Loosen mounting bolts, and remove accelerator pedal assembly.

CAUTION:
- Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.

CAUTION:
Never squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.