Component Function Check

1. Turn ignition switch OFF.
2. Disconnect EOT sensor harness connector.
3. Remove EOT sensor. Refer to "REMOVAL AND INSTALLATION ".
4. Check resistance between EOT sensor terminals by heating with hot water as shown in the figure.
   RESISTANCE REFERENCE CHART
   
   

   Terminals	Condition		Resistance (kΩ)
   1 and 2	Temperature [°C (°F)]	20 (68)	2.1 - 2.9
   		50 (122)	0.68 - 1.00
   		90 (194)	0.236 - 0.260

   Fig 1: Checking Resistance Between EOT Sensor Terminals With Hot Water

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES >> GO TO 2.

   NO >> Proceed to "DIAGNOSIS PROCEDURE ".

Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal? 

YES >> INSPECTION END

NO >> Proceed to "DIAGNOSIS PROCEDURE ".