Component Function Check
With CONSULT-III
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
- Check "BRAKE SW1" indication under the following conditions.
MONITOR ITEMS CONDITION CHART
| Monitor item | Condition | Indication | |
|---|---|---|---|
| BRAKE SW1 | Brake pedal | Slightly depressed | OFF |
| Fully released | ON | ||
Without CONSULT-III
- Turn ignition switch ON.
- Check the voltage between ECM harness connector and ground.
VOLTAGE REFERENCE CHART
| ECM | Ground | Condition | Voltage (V) | ||
|---|---|---|---|---|---|
| Connector | Terminal | ||||
| E16 | 110 (ASCD brake switch signal) | Ground | Brake pedal | Slightly depressed | Approx. 0 |
| Fully released | Battery voltage | ||||
Is the inspection result normal?
YES: INSPECTION END.
NO: Refer to "DIAGNOSIS PROCEDURE ".