LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Rogue S, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0643 To P2A00 - For CALIFORNIA >> DTC P2135: TP Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Set selector lever to the D position.
    6. Check the voltage between ECM harness connector terminals.
    VOLTAGE REFERENCE CHART

    ECM Condition Voltage
    + -
    Connector Terminal Connector Terminal
    F8 37 (TP sensor 1 signal) F8 36 (Sensor ground) Accelerator pedal Fully released More than 0.36 V
    Fully depressed Less than 4.75 V
    38 (TP sensor 2 signal) Fully released Less than 4.75 V
    Fully depressed More than 0.36 V

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Go to 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

    Replace electric throttle control actuator. Refer to " REMOVAL AND INSTALLATION ".

    INSPECTION END

scientia non olet · About LEMON Manuals