September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Accelerator Pedal Position Sensor
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check voltage between ECM terminals 110 (APP sensor 1 signal), 103 (APP sensor 2 signal) and ground under the following conditions.
VOLTAGE REFERENCE CHART
| Terminal |
Accelerator pedal |
Voltage |
| 110 (Accelerator pedal position sensor 1) |
Fully released |
0.6 - 0.9 V |
| Fully depressed |
3.9 - 4.7 V |
| 103 (Accelerator pedal position sensor 2) |
Fully released |
0.3 - 0.6 V |
| Fully depressed |
1.95 - 2.4 V |
Courtesy of NISSAN MOTOR CO., U.S.A.
- If NG, replace accelerator pedal assembly and go to next step. Refer to
ACCELERATOR CONTROL SYSTEM
.