EVAP Control Pressure Sensor

Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Refer to "REMOVAL AND INSTALLATION ".
Always replace O-ring with a new one .
Install a vacuum pump to EVAP control system pressure sensor.

Turn ignition switch ON and check output voltage between ECM terminal 42 (EVAP control system pressure sensor signal) and ground under the following conditions.

TERMINAL VOLTAGE REFERENCE CHART

Applied vacuum kPa (kg/cm² , psi)	Voltage (V)
Not applied	1.8 - 4.8
-26.7 (-0.272, -3.87)	2.1 to 2.5 V lower than above value

Fig 1: Checking Output Voltage Between ECM Terminal 42 (EVAP Control System Pressure Sensor Signal) And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION:

Always calibrate the vacuum pump gauge when using it.
Never apply below -93.3 kPa (-0.952 kg/cm² , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm² , 14.69 psi).

If NG, replace EVAP control system pressure sensor. Refer to "REMOVAL AND INSTALLATION ".