Component Function Check
- PERFORM COMPONENT FUNCTION CHECK
Without CONSULT-III
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for at least 1 minute under no load.
- Let engine idle for 1 minute.
- Open engine hood.
- Check the voltage between ECM harness connector and ground under the following condition.
VOLTAGE REFERENCE CHART
| ECM | Ground | Condition | Voltage | |
|---|---|---|---|---|
| Connector | Terminal | |||
| F11 | 50 (HO2S2 signal) | Ground | Keeping engine speed at 2, 500 RPM constant under no load | The voltage fluctuation cycle takes more than 5 seconds. 1 cycle: 0.6 - 1.0 → 0 - 0.3 → 0.6 - 1.0 |
Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE ".