Inspection Procedure

1. Turn ignition switch OFF.
2. Connect "GST" to data link connector (1), which is located under LH dash panel.
3. Turn ignition switch ON.
   Fig 1: Identifying Data Link Connector

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Enter the program according to instruction on the screen or in the operation service information.

   (*: Regarding GST screens in this part, sample screens are shown in illustration.)

   Fig 2: GST Display - Sample Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Perform each diagnostic mode according to each service procedure.

For further information, see the GST Operation Service Information of the tool maker. 

Fig 3: Gst Screens Display - Readiness Tests

Courtesy of NISSAN MOTOR CO., U.S.A.