DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   TESTING CONDITION: 

   Before performing the following procedure, confirm that battery voltage is more than 10 V at idle  .

   GO TO 2.

1. Start engine.
2. Drive the vehicle for at least 10 consecutive seconds under the following conditions.

   Vehicle speed	More than 20 km/h (12 mph)
   Shift lever	Except neutral position
   Clutch pedal	Fully released

   CAUTION: Always drive vehicle at a safe speed
3. Check DTC.

   Is DTC detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END