DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

NOTE:

If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to "DTC LOGIC ".
If DTC B210B is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to "DTC LOGIC ".

DTC No.	Trouble diagnosis name	DTC detecting condition	Possible cause
B210B	START CONT RLY ON	IPDM E/R detects that the relay is stuck at ON position even if the followings condition are met for about 1 second. Starter control relay ON/OFF signal from BCM Clutch interlock or transmission range switch input signal	IPDM E/R