Data Monitor
WARNING: This page is about a different variant/trim than selected.
| Monitor Item [Unit] | Main | Description |
|---|---|---|
| REQ SW-DR [On/Off] | x | Indicates condition of door request switch LH. |
| REQ SW-AS [On/Off] | x | Indicates condition of door request switch RH. |
| REQ SW-BD/TR [On/Off] | x | Indicates condition of trunk opener request switch. |
| PUSH SW [On/Off] | Indicates condition of push button ignition switch. | |
| IGN RLY2-F/B [On/Off] | Indicates condition of ignition relay 2. | |
| ACC RLY-F/B [On/Off] | Indicates condition of accessory relay. | |
| CLUCH SW [On/Off] | x | Indicates condition of clutch switch. |
| BRAKE SW 1 [On/Off] | x | Indicates condition of brake switch. |
| BRAKE SW 2 [On/Off] | Indicates condition of brake switch. | |
| DETE/CANCL SW [On/Off] | x | Indicates condition of P position. |
| SFT PN/N SW [On/Off] | x | Indicates condition of P or N position. |
| UNLK SEN-DR [On/Off] | x | Indicates condition of door unlock sensor. |
| PUSH SW-IPDM [On/Off] | Indicates condition of push button ignition switch received from IPDM E/R on CAN communication line. | |
| IGN RLY1 -F/B [On/Off] | Indicates condition of ignition relay 1 received from IPDM E/R on CAN communication line. | |
| DETE SW-IPDM [On/Off] | Indicates condition of detent switch received from TCM on CAN communication line. | |
| SFT PN-IPDM [On/Off] | Indicates condition of P or N position from TCM on CAN communication line. | |
| SFT P-MET [On/Off] | Indicates condition of P position from TCM on CAN communication line. | |
| SFT N-MET [On/Off] | Indicates condition of N position from IPDM E/R on CAN communication line. | |
| ENGINE STATE [Stop/Start/Crank/Run] | x | Indicates condition of engine state from ECM on CAN communication line. |
| VEH SPEED 1 [mph/km/h] | x | Indicates condition of vehicle speed signal received from ABS on CAN communication line. |
| VEH SPEED 2 [mph/km/h] | x | Indicates condition of vehicle speed signal received from combination meter on CAN communication line. |
| DOOR STAT-DR [LOCK/READY/UNLK] | x | Indicates condition of driver side door status. |
| DOOR STAT-AS [LOCK/READY/UNLK] | x | Indicates condition of passenger side door status. |
| ID OK FLAG [Set/Reset] | Indicates condition of Intelligent Key ID. | |
| PRMT ENG STRT [Set/Reset] | Indicates condition of engine start possibility. | |
| PRMT RKE STRT [Set/Reset] | Indicates condition of engine start possibility from Intelligent Key. | |
| KEY SW-SLOT [On/Off] | Indicates condition of key slot. | |
| TRNK/HAT MNTR [On/Off] | Indicates condition of trunk lid. | |
| RKE-LOCK [On/Off] | Indicates condition of lock signal from Intelligent Key. | |
| RKE-UNLOCK [On/Off] | Indicates condition of unlock signal from Intelligent Key. | |
| RKE-TR/BD [On/Off] | Indicates condition of trunk open signal from Intelligent Key. | |
| RKE-PANIC [On/Off] | Indicates condition of panic signal from Intelligent Key. | |
| RKE-P/W OPEN [On/Off] | Indicates condition of power window down signal from Intelligent Key. | |
| RKE-MODE CHG [On/Off] | Indicates condition of mode change signal from Intelligent Key. | |
| RKE OPE COUN1 [0-19] | x | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. |
| RKE OPE COUN2 [0-19] | x | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. |
| REVERSE SW [On/Off] | Indicates condition of reverse switch status. |