DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is between 10 V and 16 V at idle. 

>> GO TO 2.

With CONSULT 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to normal operating temperature.
3. Maintain the following conditions for at least 6 consecutive seconds. Hold the accelerator pedal as steady as possible.

   ENG SPEED	1, 200 - 2, 000 rpm
   COOLAN TEMP/S	More than 60°C (140°F)
   B/FUEL SCHDL	More than 4.2 msec
   Selector lever	P or N position (CVT) Neutral position (M/T)

4. Stop vehicle with engine running and let engine idle for 10 seconds.
5. Check 1st trip DTC.

   With GST 

   Follow the procedure "With CONSULT" above.

   Is 1st trip DTC detected? 

   YES >> Go to "DIAGNOSIS PROCEDURE ".

   NO >> GO TO 3.

With CONSULT 

1. Maintain the following conditions for at least 20 consecutive seconds.

   ENG SPEED	1, 200 - 3, 175 rpm (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 65°C (149°F)
   Selector lever	1st or 2nd position
   Driving location	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

   CAUTION: Always drive at a safe speed.
2. Check 1st trip DTC.

   With GST 

   Follow the procedure "With CONSULT" above.

   Is 1st trip DTC detected? 

   YES >> Go to "DIAGNOSIS PROCEDURE ".

   NO >> INSPECTION END