DTC Confirmation Procedure

PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:
- For best results, perform at ambient temperature of -10°C (14°F) or higher.
- For best results, perform at engine coolant temperature of -10°C (14°F) to 52°C (126°F).
- Before performing the following procedure, do not fill with the fuel.
  >> GO TO 2.

PRECONDITIONING-II

With CONSULT

Turn ignition switch ON.

Check the following conditions:

Ambient temperature	-10°C (14°F) or more
A/C switch	OFF
Blower fan switch	OFF

Select "DATA MONITOR" mode of "ENGINE" using CONSULT.
Check the following conditions:

COOLAN TEMP/S -10°C - 52°C (14 - 126°F)

Is the condition satisfied?

YES >> GO TO 3.

NO >>
1. Satisfy the condition.
2. GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE-I

With CONSULT

Start engine.

Drive the vehicle until the following condition is satisfied.

CAUTION: Always drive vehicle at safe speed.

STEP 1

Drive the vehicle under the conditions instructed below until the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" becomes at least 24°C (43°F).

COOLAN TEMP/S

65°C (149°F) or less

FUEL T/TMP SE

Less than the value calculated by subtracting 24°C (43°F) from "COOLAN TEMP/S".⁽¹⁾

⁽¹⁾

Example

COOLAN TEMP/S	FUEL T/TMP SE
70°C (158°F)	46°C (115°F) or less
65°C (149°F)	41°C (106°F) or less
60°C (140°F)	36°C (97°F) or less

STEP 2 (MT models)
Drive the vehicle at 60 km/h (37 MPH) or more with the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" maintained at 24°C (43°F) or more.

STEP 2 (CVT models)

Drive the vehicle at 50 km/h (32 MPH) or more with the difference between "COOLAN TEMP/S" and "FUEL T/TMP SE" maintained at 24°C (43°F) or more.

NOTE: Keep the accelerator pedal as steady as possible during cruising.
STEP 3 (MT models)
Drive the vehicle at 60 km/h (37 MPH) or more until "COOLAN TEMP/S" increases by 6°C (11°F).

STEP 3 (CVT models)

Drive the vehicle at 50 km/h (32 MPH) or more until "COOLAN TEMP/S" increases by 6°C (11°F).

NOTE: Keep the accelerator pedal as steady as possible during cruising.

Is the condition satisfied?

YES >> GO TO 4.

NO >> GO TO 1.

PERFORM DTC CONFIRMATION PROCEDURE-II

With CONSULT

Drive the vehicle until the following condition is satisfied.

COOLAN TEMP/S

65°C (149°F) or more (MT models)
59°C (139°F) or more (CVT models)

CAUTION: Always drive vehicle at safe speed.

Check 1st trip DTC.
Is 1st trip DTC detected?

YES >> Proceed to "DIAGNOSIS PROCEDURE ".

NO >> INSPECTION END