Operation Condition

Once the following condition from below is established, alert or warning is executed.

Warning/Information functions

Operation procedure

Intelligent Key system malfunction

When a malfunction is detected on BCM, "KEY" warning lamp illuminates

OFF position warning

For internal

When condition A, B or condition C is satisfied

Condition A
- Ignition switch: ACC position
- Door switch (driver side): ON (Door is open)
Condition B
- Turn ignition switch from ON to OFF while door is open
Condition C
- Intelligent Key backside is contacted to ignition switch while brake pedal is depressed and ignition switch is LOCK or OFF (When the Intelligent Key battery is discharged)
- Door switch (driver side): ON (Door is open)

For external⁽¹⁾

OFF position warning (For internal) is in active mode, driver side door is closed

NOTE: OFF position (For external) active only when each of the sequence occurs as below: P position warning → ACC warning → OFF position warning (For internal) → OFF position warning (For internal)

P position warning⁽¹⁾

For internal

Shift position: Except P position
Engine is running to stopped (Ignition switch is ON to OFF)

For external

Warning is activated when driver door is closed from the open position while the P position warning (for inside vehicle) is ON

ACC warning⁽¹⁾

When P position warning is in active mode, shift position changes P position.
Ignition switch: ACC position

Take away warning

Door is open to close

Ignition switch: Except LOCK position
Door switch: ON to OFF (Door is open to close)
Intelligent Key cannot be detected inside the vehicle

Door is open

Ignition switch: Except LOCK position
Door switch: ON (Door is open)
Key ID verification every 5 seconds when registered Intelligent Key cannot be detected inside the vehicle

Push button ignition switch operation

Ignition switch: Except LOCK position
Press push-button ignition switch
Intelligent Key cannot be detected inside the vehicle

Door lock operation warning

When door lock operation is requested while door lock operating condition of door request switch not satisfied

Engine start information

Ignition switch is ON position

Ignition switch: ON position
Shift position: P position⁽¹⁾
Engine is stopped

Ignition switch is except ON position

Ignition switch: Except ON position
Shift position: P position⁽¹⁾
Intelligent Key is in the passenger room after driver door is opened and closed.

Ignition switch is ON position to OFF position

Ignition switch: ON position to OFF position
Shift position: P position

NOTE: Engine start information turns ON for several seconds and then turns OFF, when ignition switch is turned to the ON position from the OFF position. Engine start information does not turn ON until opening and closing of driver door is detected again.

Intelligent Key low battery warning

When Intelligent Key is low battery, BCM is detected after ignition switch is turned ON

Key ID warning

When registered intelligent Key cannot be detected inside the vehicle after ignition switch is turned ON

⁽¹⁾	M/T models do not apply.