Work Procedure

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure


1. SAVING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to "CONFIGURATION (BCM) : Description" Description.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
- GO TO 2.

2. REPLACE BCM

Replace BCM. Refer to "Removal and Installation" Service and Repair.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to "CONFIGURATION (BCM) : Work Procedure" Work Procedure.
- GO TO 4.

4. INITIALIZE BCM (NATS) (IF EQUIPPED)

Perform BCM initialization. (NATS)
- WORK END