Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

VCM : Work Procedure


1. PERFORM VCM RECOMMUNICATING FUNCTION

1.Install VCM.
2.Contact backside of registered Intelligent key* to power switch while brake pedal is depressed, then turn power switch to the ON position.
*: To perform this step, use the key that is used before performing VCM replacement.
3.Maintain power switch in the ON position for at least 5 seconds.
4.Turn power switch to the OFF position.
5.Check that the vehicle can be set to READY.
- GO TO 2.

2. PERFORM ADDITIONAL SERVICE WHEN REPLACING VCM

Perform the following procedure "Removal and Installation" Removal And Installation.
- END