LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2012 >> Murano SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1212 To P2A03 (Except CROSSCABRIOLET) >> DTC P2135: TP Sensor >> Component Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

  1. CHECK THROTTLE POSITION SENSOR
    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform "SPECIAL REPAIR REQUIREMENT ".
    4. Turn ignition switch ON.
    5. Shift selector lever position to D.
    6. Check the voltage between ECM harness connector terminals under the following conditions.
    ECM Condition Voltage
    + -
    Connector Terminal Connector Terminal
    F8 37 (TP sensor 1 signal) F8 36 (Sensor ground) Accelerator pedal Fully released More than 0.36 V
    Fully depressed Less than 4.75 V
    38 (TP sensor 2 signal) Fully released Less than 4.75 V
    Fully depressed More than 0.36 V

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: GO TO 2.

  2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
    1. Replace electric throttle control actuator. Refer to "EXPLODED VIEW ".
    2. Go to "SPECIAL REPAIR REQUIREMENT ".

    INSPECTION END

scientia non olet · About LEMON Manuals