ECM: Work Procedure

WARNING: This page is about a different variant/trim than selected.

PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Insert the registered Intelligent key* into key slot, then turn ignition switch ON.
  *: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn power supply position to OFF.
5. Check that the engine starts.
  GO TO 2.
PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform the following procedure, "WORK PROCEDURE ".

END