ECM RE-COMMUNICATING FUNCTION: Special Repair Requirement

PERFORM ECM RE-COMMUNICATING FUNCTION
1. Install ECM.
2. Using a registered key (*2), turn ignition switch to "ON".
  *2: To perform this step, use the key that has been used before performing ECM replacement.
3. Maintain ignition switch in "ON" position for at least 5 seconds.
4. Turn ignition switch to "OFF".
5. Start engine.
  Can engine be started?
  
  YES: Procedure is completed.
  
  NO: Initialize control unit. Refer to CONSULT Operation Manual NATS-IVIS/NVIS.