Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT ".
4. Turn ignition switch ON.
5. Set selector lever to the D position.
6. Check the voltage between ECM harness connector terminals.

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   F8	37 TP sensor 1 signal)	F8	36 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36 V
   					Fully depressed	Less than 4.75 V
   	38 (TP sensor 2 signal)				Fully released	Less than 4.75 V
   					Fully depressed	More than 0.36 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END