Common Specifications & Procedures
ROGUE COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | ||
| Axle Nut/Hub Nut | |||
| Front Axle Nut | 180-185 N.m (133-136 Ft. lbs) | ||
| Front Hub Bearing Bolts | 88.3 N.m (65 Ft. lbs) | ||
| Rear Axle Nut | 125 N.m (92 Ft. lbs) | ||
| Rear Hub Bearing Bolts | 88.3 N.m (65 Ft. lbs) | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Front | FRONT DISC BRAKE | ||
| Rear | REAR DISC BRAKE | ||
| Torque | |||
| Front | See Torque Specifications in applicable figures under FRONT DISC BRAKE . | ||
| Rear | See Torque Specifications in applicable figures under REAR DISC BRAKE . | ||
| Charging | |||
| Alternator | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in applicable figures under ALTERNATOR . | ||
| Drive Belts | |||
| Adjustment | Vehicle equipped with auto tensioner. | ||
| Belt Routing | DRIVE BELTS | ||
| Engine Cooling | |||
| General Service Specifications | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Radiator Cap Pressure | 78.4-98.0 kPa (0.8-1.0 kgf/cm2 , 11-14 psi) | ||
| Thermostat R & I | THERMOSTAT AND WATER CONTROL VALVE | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE | ||
| Oil Pressure | |||
| @ Idle | 98 kPa (1.0 kgf/cm2 , 14 psi) | ||
| @ 2000 RPM | 294 kPa (3.0 kgf/cm2 , 43 psi) | ||
| Overhaul | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 108 N.m (80 Ft. lbs) | ||
| Fuel System | |||
| Fuel Pressure Release Procedure | |||
| Except for Mexico | FUEL PRESSURE RELEASE | ||
| For Mexico | FUEL PRESSURE RELEASE | ||
| Fuel Pressure Specification | At Idling: Approximately 350 kPa (3.57 kg/cm2 , 51 psi) | ||
| Fuel Pressure Test Procedure | |||
| Except for Mexico | FUEL PRESSURE CHECK | ||
| For Mexico | FUEL PRESSURE CHECK | ||
| Fuel Filter Location | In Tank Type | ||
| Fuel Filter R & I | |||
| Type 1 | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | ||
| Type 2 | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Engine has coil-on-plug ignition. | ||
| Ignition Wires (Routing) | Engine has coil-on-plug ignition. | ||
| Spark Plugs | SPARK PLUG Tightening torque: 19.6 N.m (14 Ft. Lbs) |
||
| Starting | |||
| Starter | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | WHEEL ALIGNMENT | ||
| Rear | WHEEL ALIGNMENT | ||
| Torque | |||
| Front | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | ||
| Rear | See Torque Specifications in applicable figures under REMOVAL AND INSTALLATION . | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 108 N.m (11 kg.m, 80 Ft.lbs) | ||
| How To Use Nissan Service Information | |||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | ||