Active Test
CAUTION:
- Never perform active test while driving vehicle.
- Make sure to completely bleed air from brake system.
- The active test cannot be performed with the ABS warning lamp and brake warning lamp are on.
- ABS warning lamp and brake warning lamp are on during active test.
NOTE:
- When active test is performed while depressing the pedal, the pedal depression amount will change. This is normal. (Only solenoid valve and ABS motor.)
- "TEST IS STOPPED" in "ABS" with CONSULT is displayed 10 seconds after operation start.
- After "TEST IS STOPPED" in "ABS" with CONSULT is displayed, to perform test again.
Test Item
ABS SOLENOID VALVE
- Select "Up", "Keep" and "Down" of "ACTIVE TEST" in "ABS" with CONSULT. Then use screen monitor to check that solenoid valve operates as shown in solenoid valve operation chart.
Test item Display item Display Up Keep Down FR RH SOL FR RH IN SOL Off On On FR RH OUT SOL Off Off On(1) FR LH SOL FR LH IN SOL Off On On FR LH OUT SOL Off Off On(1) RR RH SOL RR RH IN SOL Off On On RR RH OUT SOL Off Off On(1) RR LH SOL RR LH IN SOL Off On On RR LH OUT SOL Off Off On(1) (1) On for 1 to 2 seconds after the select, and then Off.
ABS MOTOR
- Select "On" and "Off" of "ACTIVE TEST" in "ABS" with CONSULT on screen. Make sure motor relay and actuator relay operates as shown in table below.
Test item Display item Display On Off ABS MOTOR MOTOR RELAY On Off ACTUATOR RLY ((1)) On On NOTE:(1) A brief moment of On/Off condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.